Purvario eStow Bar 100 MAXXI storage dividers - plastic, 100 mm, set of 8, light/dark grey, for campervans and boats

Purvario eStow Bar 100 MAXXI is a set of eight flexible storage dividers 100 mm high. You plug them into each other to build compartments for tall glasses, bottles and food containers in a campervan cupboard, a caravan locker or on a boat. The bars are plastic, the set mixes light grey and dark grey, and each bar is 330 mm long and 3 mm thick.

What you get in this set

• Set of 8 eStow Bar rails, type 100 MAXXI
• Height of one bar 100 mm (10 cm)
• Length 330 mm, thickness 3 mm
• Slightly flexible plastic
• Colours in the set: light grey and dark grey
• Perforation every 3 mm - score with a craft knife and snap off
• Plug-in system: bars lock into each other to form compartments
• Net weight of the set 600 g, gross 650 g
• Shop code 551119

How the plug-in system works

eStow Bar rails work like comb dividers: you plug the fine teeth on the long edge into the neighbouring bar and build a rigid grid. The denser the joints, the smaller the cells for small packs.

Light grey and dark grey in one set make it easier to mark zones in a cupboard - a darker bar can show a drinks side versus spices, without extra labels.

What this model is for

Choose 100 MAXXI when you carry tall glasses, bottles, cans and food boxes upright. The 100 mm height supports them, and the interlocked teeth limit tipping on the road.

Use covers a campervan, caravan, yacht, car travel and also home drawers or cabinets when you need tall dividers. Bars of the same family (30 mm, 60 mm and 100 mm) can be combined.

The maker recommends an anti-slip mat under the set. The bars also work with the studded nub plate and with Purvario storage boxes and towers - you just clip them on.

The eStow Bar family covers three heights: 30 mm with fridge clips, 60 mm for drawers and 100 MAXXI for tall vessels. You can buy several sets and run one continuous system through the vehicle kitchen.

The 3 mm perforation comes from the maker's datasheet. Score precisely with a craft knife, then snap the surplus on a stable surface.

The maker designs the bars to clip onto a nub plate and onto Purvario storage boxes and towers. Under a set in a plain cupboard, add an anti-slip mat.

How to assemble and trim the bars

1. Take the 8 bars out of the pack. Lay them on a table and plan the grid for your glasses or bottles.
2. Plug the teeth into each other at a right angle until you have a stable lattice. The fine tooth pitch lets you set almost any spacing.
3. If a bar is too long, score it with a craft knife on a 3 mm perforation line and snap it off. Keep the bar on a stable, non-slip surface while you cut.
4. Place the finished grid in the cupboard. Put an anti-slip mat underneath. On a nub plate, just push the bars onto the studs.
5. Check that tall vessels stand upright and that the grid does not loosen when you shake it lightly.

What is in the box

• 8 Purvario eStow Bar 100 MAXXI rails (light grey and dark grey)
• No anti-slip mat and no nub plate - you add those separately

Which height to pick

Pick 100 MAXXI (this product) when you carry tall vessels and need 10 cm of support. For typical drawers take 60 mm (card 34531). For a fridge with a wire shelf take 30 mm with clips (card 34530). All three heights join into one system.

The plastic flexes slightly, so a bar follows light unevenness of a drawer base, but it does not replace load securing in a vehicle. With tall vessels, always check that the grid stays tight after a light shake.

Points to watch in use

• The product is for private use only, not for commercial use.
• Keep the bars away from heat sources.
• When cutting on the perforation, work on a stable surface that cannot slip.
• The set may contain small parts - it is not a toy; keep it away from small children.
• Do not exceed 55 °C in the dishwasher - a higher temperature can damage the plastic.
• Clean with a damp cloth and a mild soap solution; avoid solvents and abrasives.
• Use an anti-slip mat under tall vessels; the bar system alone does not replace load securing in a vehicle.

Care

Wipe the bars with a damp cloth and a mild detergent. You may wash them in a dishwasher up to 55 °C. Do not use steel wool or abrasive paste. After shortening, smooth any burrs on the cut edge.

The set is for private use. Keep it away from heat sources. In a dishwasher do not exceed 55 °C. For hand cleaning a damp cloth and mild soap are enough.

Each single bar is 330 mm long and 3 mm thick. Height differs by model: 30, 60 or 100 mm. The pack size in the table is the set carton, not one bar.

Related products

• Purvario eStow Bar 60 mm for drawers - lower bars for typical drawers
• Purvario eStow Bar 30 mm for fridges - low bars with clips for the fridge
• Purvario eStow Bar 100 MAXXI lime - same 100 mm model in lime/anthracite

Technical data

Manufacturer

Dörr GmbH & Co. KG (purvario), Ohmstrasse 2, 74211 Leingarten, Germany